新闻资讯

With tPre - issued procedure of EPS Batch pre-expander machine pre-issued, according to the different expansion ratio, the hourly production efficiency is different.

1, pre-clear the barrel of debris, close the cleaning door, open the air valve and steam valve. Prepare the raw material and press the delivery button. Set the amount of feed, the weighing switch will be placed in the automatic position, the counter set the number of times required to confirm the time set each step, waiting for the material full of the signal. Fan and the screen, the selection button placed in the automatic, press the preheat button, preheat 6min, according to set the number of pre-issued, the hair machine will automatically repeat the pre-process.

2, the end of the pre-release When the last run of the end, left in the hopper when the weight of raw materials is insufficient, the switch dial to semi-automatic, press the "remaining pre-hair" button, the remaining material will be shorter than the previous process 5s short time carry out. This switch is only valid at the end of the previous operation of 50 ~ 300s, beyond this range need to manually. In the automatic mode down, to manually clean the tube, will remain in the pre-cylinder within the beads cleared. Off the steam and the air total valve, cut off the power.

上一条: EPS molding machine system program
下一条: EPS BLOCK MOLDING MACHINE